Remark:

* The AI features described on the page may not be included in the software version at launch. In some countries and regions, these AI features will be updated via OTA. Please refer to the features in the actual version. * An Account login may be required to access certain realme AI features. * realme AI features will vary due to regional laws and cloud-based capability of the user's location. You need an internet connection to use AI-related features. * realme features including AI features displayed on the product pages in this website (including but not limited to UI and background) are only to demonstrate the functions. These functions are part of the various software versions and may vary according to the time and place (region) of launch of the different software versions. Please refer to the functions and pages in the actual version. *Product images are for reference only. Please refer to the actual product. Product specifications and descriptions may vary due to supplier changes or other factors. All data is based on realme's technical design parameters and laboratory test results. Actual performance may vary depending on the test environment, software version, and individual product. * realme P4s Lite supports IP64 waterproof and dust-proof rating, which can prevent splashing, water, and dust in normal use. Under controlled laboratory conditions, it has been tested to meet the IP64 level according to GB/T 4208-2017 (China)/IEC 60529 (International) standards. The IP64 waterproof conditions are as follows: (1) Nozzle inner diameter 0.4mm, distance 20cm; (2) Water flow rate 10.5L/min; (3) Test time not less than 10 minutes; (4) Water temperature should not differ from the product temperature by more than 5℃. The splash-proof, waterproof, and dust-proof functions may decrease due to daily wear and tear. Please do not charge the phone in a damp state. Damage caused by immersion in liquids is not covered by the warranty. *The actual experience may differ due to the environment and personal usage habits. Please refer to actual experience. The test is performed using an IPX1 drip rain test device. The device under test is installed in its normal operating position below the drip tank (height in accordance with IPX1 standard methods). The entire screen area is subjected to a water flow of 1 mm/min, and finger operations are used during the test to verify the wet-hand touch performance. 1. The equivalent typical value of battery is 7000mAh, and the equivalent rated value is 6820mAh. All battery claims depend on network configuration and many other factors, actual results will vary. The battery will have a battery capacity retention rate of more than 80% after 6 years of use according to realme lab simulation of the user's daily behaviour (full charging-discharging once every 1.3 days). The data was obtained from realme Labs and will differ slightly due to the test software version and specific testing environment. Due to variations in individual usage patterns, the number of full charge cycles a phone battery completes within a six-year period may vary. Natural degradation of battery capacity retention resulting from normal use is not covered under the warranty. 2. realme P4s Lite can reverse-charge other devices via its charging ports, with a 5V/1A (Average) charging power. This function depends on USB-OTG and a dedicated C-to-C cable. It can only be realised after the USB-OTG function switch is turned on in the mobile phone setting interface. Theoretically, all OTG-supported phones or products can reverse-charge, but due to varying OTG output performance, charging failure or displayed charging with decreasing power may occur. Please refer to actual use, using realme official C-to-C cables is recommended for safety. The product interface content shown above (including but not limited to UI and background) is for functional display only. 3. Screen size is measured diagonally. The screen size is 17.15cm as a full rectangle, The actual viewable area is less due to the rounded corners and camera hole. Please refer to the actual product. 4. The screen supports up to 120Hz refresh rate. The refresh rate may be different under different apps and scenarios. Please refer to the actual use. 5. realme P4s Lite has passed the 36-Month Fluency Protection test in realme laboratory. "Fluency Protection" means that the device has passed the corresponding fluency testing based on software optimization, hardware optimization, and other comprehensive technical improvements. This does not guarantee absolute freedom from lag. Actual performance may vary due to network conditions, usage patterns, individual product differences, and other factors. Please refer to actual experience. 6. ArmorShell™ Protection means the device meets realme quality standards through various optimizations. 7. The device has passed the MIL-STD 810H military-grade shock resistance test, which includes multi-angle drop tests, high-intensity impact tests, and other high-standards durability tests. Due to factors such as machine aging and personal usage habits, the experience may vary. Please refer to your actual experience. Damage caused intentionally by human factors is not covered by the warranty. 8. Based on tests conducted by realme Lab. This rating ensures that the device is protected against limited dust ingress and water spray from any direction. The resistance to splashes, water, and dust is not permanent and may be reduced due to daily use. 9. The rear camera defaults to 13MP. High-resolution mode can be manually enabled via Camera - More - HI-RES to capture 50MP photos, which are achieved through software upscaling algorithm. 10. The feature is supported in the general mode of the rear camera.